GCC is pleased to share a new application, magnet cutting. By using the GCC RX and Jaguar IV series cutting plotters and the add-on flat table, users can effortlessly adopt magnet cutting applications. Through such technology, you can not only make various magnets for families and friends on your own, but also establish your own small family businesses for extra income. The magnet application has been widely seen in a number of occasions from restaurant designs to vehicle decorations. You can produce magnets of all kinds in a small volume through the following easy procedures. |
Create an image in CorelDraw, set the contour line width as 0.001mm and go to "Print" under "File". |
Go to the Layout page and select Bottom left corner at “Reposition images to”. |
Attach the magnetic sheet to a piece of adhesive film before clicking “Print”. |
Note: Make sure that you place the magnetic sheet with the magnetic side facing up so that it will not stick to the platen. Magnet applications through GCC Cutting Plotters. |